Fences are either open, to use as a trellis for
roses or other plants, or they are closed to serve as a wind, sun or privacy
screen.
The materials will depend largely upon the use to which the fence is to be
put. The most popular, and probably the most attractive, fences are built of
wood in various forms, but newer fences of asbestos-cement and corrugated
sheet metal are colorful and stand up against rot better.
Because they are heavier, they are usually erected in a zigzag design, the
better to stand up against prevailing winds.
The major problem in prolonging the life of a fence stems from rot at the
ground line, for here it is susceptible to alternating wet and dry conditions. |
|
|
Among the best woods for
withstanding rot are California redwood and Southern cypress, white cedar and
red cedar, chestnut, locust and arbor vitae. While painting the wood with
preservatives often lengthens the life of your fence, this will do no good
unless the preservatives penetrate.
That's why a post that has been machine-creosoted will resist rot, while a
hand-creosoted post will not. However, if you use a good preservative on a
clean, dry, unpainted wood, and give the wood two or three coats, you can do a
good job.
Among the commercial wood preservatives you will find those of
pentachlorophenol, copper napthenate (which has a green color) and zinc
napthenate, a clear solution.
In addition to the point where the post hits the ground, any place where two
pieces are nailed together on a wooden fence is subject to rot. Therefore, it is
wise to treat the wood where the members are joined before you put up the fence.
This will preserve it much better than painting afterward.
Set your fence posts deep enough in the ground to resist the prevailing winds,
at least 2 feet and even deeper. Set heavy posts in concrete. Tamp firmly in
place so the fence will not wiggle. Hardware used should be galvanized.
Among the most popular types of fences are the traditional picket, the
post-and-rail fence and the hurdle fence, but with increased stress on privacy
screening, the louvered and lattice types are ever more popular.
The post-and-rail fence is made of posts spaced at 10 foot intervals with large
slots cut in them. The 11-foot-long rails are tapered to flat ends, which are
inserted in the posts. The hurdle fence has split rails built into a braced
frame and nailed together, with the end pieces of each panel becoming the posts.
The picket fence, traditionally white, has posts spaced from 8 to 12 feet apart,
rails 3x4 inches, and pickets 2 to 3 inches wide, pointed at the top.
The pickets should be 2 inches off the ground at the bottom and extend well
above the top rail. The spindle fence is a kind of picket fence with round
spindles that pass through holes in the rails.
There are many possible variations of board fences used for screening. A broad
rail may be alternated with a narrow rail, or the boards may be applied
vertically, like palings, with, perhaps, a staggering of the boards on either
side of the rail. Boards may be slanted in a louver effect to give privacy while
admitting air and sunlight.
A basket-weave fence can be constructed of thin, flexible boards and provides
total screening and a handsome background for planting. It is somewhat difficult
to build yourself, however.
This article courtesy of:
http://articles.net.au
Amazing Gardens is an
informative Gardening site that looks into all aspects of Gardening from Plants
to Fences. To find out more visit
Gardening
Find Fence Contractors. Get Up to 4 Quotes Now. It's Quick, Free, and Easy!
Related Tips and Advice:
|
