|
o Tape measure
o Utility knife
o T square: get a large size. Look for a four foot square to reach across a full
sheet of drywall. This tool is important for accurate measuring and cutting.
o Corner tool: these come in either steel or plastic. Some people use both,
depending on the job. The difference is largely a matter of preference.
o 4.5 inch steel knife to fasten the tape to the wall
o 10 inch steel knife for finishing
o Stainless steel mud pan for mixing compound. Stainless is the best choice, as
it won’t rust.
Supplies needed:
o Paper tape for drywall taping. Paper is the best choice as the knife moves
easily over this material.
o Sandpaper in both 100 and 220 grit
o Drywall compound: look for an all purpose compound. These are easy to apply
and dry evenly.
o Drywall sheets
o Screws
o Nails
o Drop cloths
o Keyhole saw
o Steel ruler
How to Work with Drywall Tools
Complete tutorials for hanging drywall are available on the internet. Many home
improvement stores offer workshops on drywall that last from a day to a weekend.
These are good choices for the beginner. A major mistake many people make is
trying to do the job too quickly. It’s better to go slow and take several days.
The results will be more professional and you will be happier when you are
finished.
Start out by sketching out your plan on paper. Take accurate measurements of the
room to determine how many sheets of drywall you will need. Allow a bit extra
for waste. Decide on the type of drywall you need. Green board is made for areas
prone to moisture, such as the bathroom.
In general, you should start with the ceiling and then do the walls. Start at
the top of the wall, near the ceiling and move downward. Keep the seams as tight
as possible to help limit the amount of sanding and smoothing you need to do
later. Use your T square to accurately measure the drywall. Score with your
utility knife and then break the sheets. Attach these to the wall in a way that
leaves the least number of seams possible.
Once the drywall is hung, you will tape over the joints. Tape firmly and smooth
with a finishing knife. Use your knife to smooth out the compound. Smooth the
corners with your corner tool. Allow this to dry for at least twenty four hours.
At this time, you can sand the drywall and add another coat. Wait another day
before applying the third coat and sand this after another twenty four hours has
passed. This will ensure the best possible installation and smoothest finish.
About the
author: Ciara McNamara works for
http://www.inside-woodworking.com a website with resources. In his
publication the author is specializing in tips on
drywall tools .
Article Source:
http://www.Article-Content-King.com
Find Drywall & Insulation Contractors. Get Up to 4 Quotes Now. It's Quick, Free, and Easy!
Related Tips and Advice:
|
